|
|
|  | 
Puck Style Transducers
TB0023
Wide 19 Degree Puck Transducer. For Mounting on a Electric Trolling Motor, In-Hull Mounting, Portable Use, or Ice Fishing. Comes with 25 Feet of Cable.
Trolling Motor Mounting
To attach a Puck style transducer to a trolling motor use the large cable tie provided. Notice the slots in the transducer for this purpose.
Locate the transducer on the bottom of the lower unit. Run the cable up the shaft using smaller cable ties to hold it in position.
Make sure that the motions of the trolling motor will not damage the cable. Plug the transducer connector into the back of the unit and screw the retaining ring down tight.
In-Hull Mounting
Finding the best location for the transducer before you mount it is critical. Choose a flat smooth spot near the center of the bilge and near the back of the boat. It is a good idea to make a "test run" before you permanently install the transducer to make sure that you can indeed get a reading through your hull and when the boat is on plane. Put about a half inch of water in the bilge and hold the transducer in the intended location. Move the transducer around until you get the best reading. Mark that spot.
To install the transducer clean the spot of mud and oil. Using an epoxy or silicone glue make a puddle about the same diameter as the transducer on the hull. Place the transducer in the glue. Press it down firmly, gently twisting it back and forth, making sure that there are no air bubbles in the glue between the transducer and the hull. Let the glue dry completely before turning the unit on.
Run the transducer cord up to the unit taking the same care as you did when you ran the power cord. Plug the transducer connector into the back of the unit and screw the retaining ring down tight.
|
|
|
We accept:
|
|
